Comparison

ELISA Kit for Proinsulin (PI)

Item no. SEA379Hu-96T
Manufacturer Cloud-Clone
Amount 96T
Category
Type Elisa-Kit
Applications ELISA
Specific against Human
ECLASS 10.1 32160605
ECLASS 11.0 32160605
UNSPSC 41116126
Alias E90379Hu, sE90379Hu
Similar products PI
Available
Quantity options
Quantity options
Alternative Names
INS, Pro-Insulin, Preproinsulin
Detection range
12.5-800pg/mL The standard curve concentrations used for the ELISA’s were 800pg/mL, 400pg/mL, 200pg/mL, 100pg/mL, 50pg/mL, 25pg/mL, 12.5pg/mL
Sensitivity
The minimum detectable dose of this kit is typically less than 47pg/mL
Sample type
Serum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
Assay length
4.5 hours
Method
Sandwich
Specificity
This assay has high sensitivity and excellent specificity for detection of Proinsulin (PI).
No significant cross-reactivity or interference between Proinsulin (PI) and analogues was observed.
Precision
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Proinsulin (PI) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Proinsulin (PI) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Stability
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary
1. Prepare all reagents, samples and standards;
2. Add 100µ L standard or sample to each well. Incubate 2 hours at 37oC;
3. Aspirate and add 100µ L prepared Detection Reagent A. Incubate 1 hour at 37oC;
4. Aspirate and wash 3 times;
5. Add 100µ L prepared Detection Reagent B. Incubate 30 minutes at 37oC;
6. Aspirate and wash 5 times;
7. Add 90µ L Substrate Solution. Incubate 15-25 minutes at 37oC;
8. Add 50µ L Stop Solution. Read at 450nm immediately.
Test principle
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Fucosidase Alpha L1, Tissue (FUCa1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Fucosidase Alpha L1, Tissue (FUCa1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Fucosidase Alpha L1, Tissue (FUCa1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Fucosidase Alpha L1, Tissue (FUCa1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Note: The presented information and documents (Manual, Product Datasheet, Safety Datasheet and Certificate of Analysis) correspond to our latest update and should serve for orientational purpose only. We do not guarantee the topicality. We would kindly ask you to make a request for specific requirements, if necessary.

All products are intended for research use only (RUO). Not for human, veterinary or therapeutic use.

Amount: 96T
Available: In stock
available

Compare

Add to wishlist

Get an offer

Request delivery time

Ask a technical question

Submit a bulk request

Questions about this Product?
 
Close